The RKG-3 Entry Door Tilt Up Station is designed to raise assembled entry door units from a horizontal to a vertical position, for feeding into the RKG 4 Upright Clamp Conveyor.

This station is designed with non-marking polyurethane wheels to support the door on the top and bottom rails. The wheels are positioned so door light frames and raised moldings will not be damaged. There are also rolls on the sill support plate. These wheels enable one operator to safely and easily move the door unit to the next station. The tilt table utilizes a hydraulic tilt cylinder, electric pump, and foot switch for control.

A three-phase electric supply, in addition to the air supply, must be provided for the RKG-3.

The standard machine will accommodate doors that are 6’8” high only, and doors that vary in width from 2’6” to 3’0”. With the optional 8’0” door capacity option, the machine can be set up to accommodate doors that vary in height from 6’8” to 8’0”. The RKG3 will accommodate jamb widths up to 6-9/16”.