RKG-2 Entry Door Brick Mold Station is for applying exterior casing to steel, fiberglass, or wood door units with side lights, patio door units or double doors.

This station is designed to receive an assembled door unit from the RKG-1 Entry Door Assembly Station on non-marking polyurethane wheels that supports the doors on the top and bottom rails. After the door unit is in the station, the unit is lowered approximately 5” and set onto support plates so it will not move. The lowered height makes it easier and safer for the operator to apply the outside casing and any required packaging. This would include a skid board to protect the sill from damage.

After the outside casing and packaging have been applied, the door unit is raised up on the polyurethane wheels so that it can safely be rolled to the next station.

The standard RKG-2 Entry Door Brick Mold Station will accommodate doors 6’8” high and doors that vary in width from 2’6” to 3’0”. With the 8’0” door capacity option, the RKG-2 can be set up to accommodate doors that vary in height from 6’8” to 8’0”. This station will accommodate all jamb widths.

With Option B, assembled transoms can easily be attached to 6’8” only. **NOTICE** When this option is selected, the 8’0” option for the RKG-4 Upright Conveyor must be specified.